Vintage Swarovski Cube Necklace Kit Instructions

0 comments
Cut a foot off of your knotting cord and set aside.On your head pin add the following.Silver Bead / Bead Cap (Prong side facing up / Vintage Swarovski Cube / Bead Cap (Prong side facing down) / Silver Bead.Wrap your head pin following the guide.Trim excess wire.Open your jump ring, and add your necklace drop. Close jump ring and slide onto your knotting cord.Over lap the ends of your cord, and create your sliding knot.Once complete, secure with glue.Add a silver bead to each end of your knotting cord, and create a knot to hold them in place.

Leave a comment

All blog comments are checked prior to publishing
You have successfully subscribed!
This email has been registered