DIY Jewelry Kit - Swarovski Caviar Crystal Bracelet Kit Instructions

1. Unpack Your Kit: After you've unpacked your kit, make sure you have all the necessary components ready.

2. Cut the Leather: Take your length of leather and measure out five separate 7-inch sections. Use a sharp tool to cut these sections accurately.

3. Position the Slider: Center the slider on the strands of leather you just cut. This should be placed approximately in the middle of each leather piece.

4. Check Your Bracelet Size: Now that you've positioned the slider, wrap the bracelet around your wrist to check the fit. The bracelet should be comfortable and not too tight.

5. Trim the Leather: If necessary, trim the ends of the leather sections to adjust the bracelet size. Make sure to cut the same amount off each strand to keep the bracelet even.

6. Glue the Ends: Once your bracelet is the right size, apply a small amount of glue to the inside of the clasp and insert the ends of your leather strands. Make sure each strand is fully inserted and holds firmly. Let the glue dry thoroughly before wearing your new bracelet.

Congratulations! You have just created a beautiful piece of jewelry with your DIY kit. Enjoy wearing your unique bracelet or gift it to a loved one!