Looking for Instructions?

DIY Sun Catcher Kit - Tangerine Dreams Earring Kit Instructions

Once your unpacked your pick, we will begin with the 20mm sphere.

  • Center your sphere on your wire
  • Add 4 hearts to each side of your wire
  • Bring your wires together
  • Add your 3mm bead
  • Add a cone bead facing up
  • Now add a flat bead (Point facing up)
  • Rondell
  • Flat bead, Point Down.
  • Cone Bead, facing down.
  • 2 hearts
  • a cone bead facing up
  • now add a flat bead (Point facing up)
  • Rondell
  • Flat bead, Point Down.
  • Cone Bead, facing down.
  • 2 Hearts
  • a cone bead facing up
  • now add a flat bead (Point facing up)
  • Rondell
  • Flat bead, Point Down.
  • Cone Bead, facing down.
  • Add a 4mm bicone
  • Straighting your sun catcher, and tighten with your pliers.
  • Create a wrapped loop with both wire, makig sure your hole is large enough for your jump ring.
  • Trim excess wire.
  • Use jump ring to attach your chain.
  • Check length, and add your second jump ring.

We hope you enjoy this Sun Catcher!

 

 

 

 

Updated on 25 Apr 2023