Looking for Instructions?

DIY Jewelry Kit - Swarovski Jonquil Butterfly Bracelet Instructions

DIY Jewelry Kit - Swarovski Jonquil Butterfly Bracelet Instructions

Step 1: Begin by cutting your wire in half. Divide your beads in half.
Set one half aside for the later part of your bracelet.

Step 2: Take the first half of your wire. Add your butterfly connector and center on the wire

Step 3: Take both ends of the wire through a 3mm silver round bead.

Step 4: Add two jonquil 5mm Swarovski beads.

Step 5: Add another 3mm silver round bead.

Step 6: Repeat steps 4 and 5 until you have used all your beads.

Step 7: Add a crimp tube your wire guard, then your lobster claw clasp. Thread the wires back through the wire guard and your crimp tube and your swarovski round beads,add crimp cover.

 

Step 8: Pull the wires tightly and crimp the crimp tube to secure the wire guard and clasp.

Step 9: Take the second half of your wire and repeat steps 2 to 8, replacing the lobster claw clasp with the extension chain.

Take your head pin add crystal butterfly bead a 3mm round.

start your wrap add chain,compleat your wrap.

 

 

Updated on 13 Jun 2024