DIY Jewelry Kit - Shimmering Swan Bracelet Kit Instructions

Set Up Your Wire and Chain: Attach your beading wire to one end of your chain. Take an eyepin and attach it to the other end of your chain.

Create Your Bead Sequence: On your eyepin, add a 3 mm bicone bead, followed by a 4 mm multi-cut bead, and then another 3 mm bicone bead. Now, begin to wrap your eye-pin (do not complete your wrap).

Add Your Clasp: Attach your lobster clasp onto yout wrap and finish.

Continue Your Pattern: Add three shimmer beads and then a 4 mm multi-cut bead. Repeat this pattern four more times, until you have used all of your beads.

Cut Your Wire: You will now need to cut off a small piece of wire, leaving the other wire connected to your chain. Count up six links from where your beads end and put the small wire through a loop.

Your Wire: Hold your bracelet up by the long piece of wire.

Cut Your Chain: Cut your chain in the loop right above your small piece of beading wire.

Attach Your Eyepin: Open your eyepin and add it to the loop right above your small piece of beading wire and close it.

Repeat Your Bead Sequence: As we did in the beginning, add your 3 mm bicone, your multi-cut bead, your 3 mm bicone. Start your wrap, add the small loop on extension chain and complete your wrap.

Measure and Finish: Measure your bracelet to see how much extension chain you want. Use a jump ring to add your swan charm at the end.

Congratulations! You've just completed your beaded bracelet!