Looking for Instructions?

Two Tone Lariat Kit Instructions

 
Assemble your button following the image and run both end of your leather through the opening. DO NOT try to force the button together. Squeeze just enough to align the openings.
 
Put the leather, with the button over your head to determine where you would like your necklace to sit. Once you’ve determined your length, use
scissors to trim the ends of the leather on a slight angle. At this point, add 1 pyramid cut bead to each side of the leather.
Add a drop of glue to the end of your leather and slide the it into your end cap. Repeat this for the other end of your leather. Be sure the circle of end cap is facing the same direction as your slider.
 
Use your pliers to open your jump rings. 
 
Attach your pears and end caps, then close your jump rings.
 

 

 

Updated on 20 Sep 2022