Crystal Oval Shamballa Bracelet Kit

Before Begining, Cut your knotting cord into 5 2 foot sections

Step 1: Start out by taking 1 of your 2ft sections of cord and folding it in half together, Now you'll run the end of the cords with the loop down through your oval, Then take your 2 ends and put them inside the loop and pull to secure vour knot.

Step 2: Take another 2ft section of cord and center i oval so that there is 1 on each side and begin your square knot.

• Right cord over center cords and under left cord, left cord under center cords and up through the loop and pull tight
• Left cord over center cords and under right cord, right cord under center cords and up through the loop and pull tight

Repeat each knot 17 times to complete 18 full knots.

Cut the excess cord you used to knot and glue it.

Step 3: Now repeat steps 1 & 2 on the other side of your infinity.

Step 4: Once both sides of your bracelet are completed you'll take your bracelet and lay it horizontally across your clipboard and clip both sides across each other so that all 4 cords are aligned.

Step 5: Now start your square knot again. Make about 7-8 full knots or as many as needed to fit vour wrist.

Then nip the excess cord you used to knot and glue it.

Step 6: Now you'll hang a silver ball from each pull cord and knot underneath the ball then cut the excess cord and glue it. *Note* Be sure to make all the pull cords even and to leave vourself enough room to get the bracelet on and off.