Swarovski Crystal & Tree Of Life Charm Bracelet Kit Instructions

Step 1: Start by taking one end of your chain and add your eye pin to it. Close the eye pin securely.

Step 2: Now, add a 4 mm crystal round bead to the eye pin.

Step 3: Begin wrapping the wire around the eye pin. Stop halfway through the wrap and add your lobster clasp to the eye pin. After adding the clasp, complete the wrap.

Step 4: Take the wire provided and thread it through the end of your chain. Start adding your beads in this order:

• an 8 mm round crystal
• a 2 mm silver bead
• an 8 mm round crystal
• a 2 mm silver bead
• an 8 mm round crystal
• a 2 mm silver bead
• a rondelle bead
• a 2 mm silver bead.

Step 5: Repeat this pattern until you have used all of your beads.

Step 6: Very carefully take the wire you just used and position it approximately 3 to 4 links above your last bead. Make sure to leave the wire attached.

Step 7: Thread your eye pin through the last link of the chain and close it. Add a 4 mm round bead to the eye pin and begin your wrap.

Step 8: Add your extension chain to the wrap, then close it.

Step 9: Determine the size of your bracelet.

Step 10: Open a jump ring, add your charm to it, and close it securely.