Magnificent Metals Bangle Bracelet Kit Instructions

Before we begin assembling the bracelet, we need to cut our chain

Hold your chain, countdown five links, and cut on sixth.

Do this 11 more times. 

The remaining chain is used at the end of your bracelet.

Set your chain aside, and we will assemble the front section of the bracelet first.

Take your silver closed ring and center it on your wire.

Add a crimp tube, pull tightly and crimp.

Add your Crystal bicone.

Separate your wires and the following to each wire.

• 2mm Rose Gold Bead
• Pyramid Cut Bead Rondell
• 2 mm rose gold
• Silver tube on one wire, Rose gold tube on the other wire.
• 2mm Rose Gold Bead
• Pyramid Cut Bead Rondell
• 2mm rose gold
• Run your wire through your Chaton
• 2mm rose gold Bead
• Pyramid Cut Bead Rondell
• 2mm Rose Gold Bead
• Silver tube on one wire, Rose gold tube on the other wire.
• 2 mm rose gold
• Pyramid Cut Bead Rondell
• 2mm Rose Gold Bead

Bring your wires together, add a bicone, crimp tube another closed ring.

Back your wires through the crimp tube and bicone pull tightly make sure everything is straight and crimp

Cut excess wire.

Next we will complete the sides of the bracelet with jump rings and chain.

For the next steps it is best to open all your jump rings.

Open a rose gold jump ring, and add 3 of your small chains. 

Attach to your closed ring and close the jump ring.

Now, take another rose gold jump ring, and connect the other side of those 3 small chain, then add another 3 chains, and close the jump ring

Take another rose gold jump ring, add the remaining side of the 3 chains, along with your magnetic clasp and 1 half of your saftey chain, and close.

Repeat for the others side of your bracelet.